airbenchrest.ru http://airbenchrest.ru/phpBB3/ |
|
.22LR Go Gauge & chamber http://airbenchrest.ru/phpBB3/viewtopic.php?f=14&t=132 |
Страница 1 из 1 |
Автор: | spurlos69 [ 01 янв 2013, 17:45 ] |
Заголовок сообщения: | .22LR Go Gauge & chamber |
Возник вопрос по посадке патрона в патронник. Чтобы установить ствол в Аншике 2013 http://www.riflebarrels.com/products/an ... arrels.htm рекомендуют использовать такую вот хрень http://www.riflebarrels.com/products/22_go_gauge.htm Там написано про размер 0,043" это 1,0922мм я так понимаю что это величина закраины. Перемерял все гильзы, что у меня есть, размер закраины составляет 1,0-1,02мм Теперь вопрос: если установить ствол по этому Go Gauge, то патрон не будет садиться до конца, примерно на 0,1мм. Правильно ли это? Этих Go Gauge полным полно, на каждый калибр http://www.midwayusa.com/find?newcatego ... ionid=1124 Вот видео, кто английский шарит, расскажите что там говорят. http://www.youtube.com/watch?v=zqBQ3GcVHMo http://www.youtube.com/watch?v=JODd4h_BWWI Вот еще надо перевести: Headspace gages are available in three different lengths, listed below, from shortest to longest: - Go Gage: Go Gages match the minimum chamber dimensions allowable under SAAMI specifications. In order to accept SAAMI maximum ammunition, the rifle must be able to chamber the correct go gage. - No-Go Gage: No-Go Gages are sized to the maximum recommended headspace dimensions. If a rifle will chamber the no-go gage, it may still be within specifications, or this could indicate excessive headspace. To determine if the rifle is safe to shoot, the chamber must be checked with the field gage. - Field Gage: Field Gages correspond to the maximum safe headspace dimension. If a rifle will chamber a field gage, it should be inspected and repaired by a competent gunsmith prior to use. Параллельное обсуждение: http://airgun.org.ua/forum/viewtopic.ph ... 00#p806300 |
Страница 1 из 1 | Часовой пояс: UTC + 4 часа |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |